Page "hobbies" Paragraph 478

To assemble lid, press clay piece C in cavity of wooden design head.

Press clay into mold as instructed in General Directions.

Score plain side of C and leave in mold.

Score one side of disk D, join to C ; ;

score other side of D and one side of disk E and join as before.

While assembled lid is still on design head, gently but firmly press it on plaster board.

If design head has a deep cavity, clay lid will be quite thick at this point ; ;

press eraser of pencil gently 1/4'' '' deep into deep clay to allow vent for proper drying and firing.

Check fit of lid on jar ; ;

if inner lid is too big, trim to fit, allowing room for thickness of glaze.

Remove lid from head of mold.

Remove jar from mold.

Place jar on plaster board with lid in place to dry slowly.

Bisque fire to cone 08 with lid on jar.