Help


[permalink] [id link]
+
Page "Wide receiver" ¶ 4
from Wikipedia
Edit
Promote Demote Fragment Fix

Some Related Sentences

receiver's and also
Waypoints can also be marked on a computer mapping program and uploaded to the GPS receiver, marked on the receiver's own internal map, or entered manually on the device as a pair of coordinates.
However in crystal sets, the impedance of the antenna-ground system ( around 10-200 ohms ) is usually lower than the impedance of the receiver's tuned circuit ( thousands of ohms at resonance ), and also varies depending on the quality of the ground, length of the antenna, and what frequency the receiver is tuned to in the band.
This also improved the receiver's selectivity ( see below ).
Not only can solid black be used, but also images which will repeat endlessly on the receiver's machine until its toner runs out.
In properly engineered systems, multipath can also be reduced by assuring that the transmitter uses only the minimum necessary power, allowing the reflected signals to be lower than the receiver's detection threshold.
Practitioners may also use tools such as crystal wands, which are placed near the receiver's body, or near a certain ' blocked ' chakra, or use to perform psychic surgery, normally conducted with laser quartz wands.
When the transmitter sparked, small sparks also appeared across the receiver's spark gap, which could be seen under a microscope.

receiver's and expected
The insignia are expected to be returned either upon the receiver's advancement to a higher level of the order or upon his or her death.

receiver's and role
The wide receiver's principal role is to catch passes from the quarterback.
The lower the value of GDOP then the better the ratio of position error to range error computing will be, so GDOP plays an important role in calculating the receiver's position on the surface of the earth using pseudoranges.

receiver's and ;
The sender's personal filters and the receiver's personal filters may vary depending upon different regional traditions, cultures, or gender ; which may alter the intended meaning of message contents.
Unlike more costly units, low-cost toy walkie-talkies may not have separate microphones and speakers ; the receiver's speaker sometimes doubles as a microphone while in transmit mode.
* Shaw Direct satellite invokes simsubs according to the subscriber's postal code, and is implemented by the receiver's firmware ; this method enforces simsubs only in areas where they are legally needed.
Deep-throating leads to an entirely different kind of oral stimulation in comparison to regular fellatio, while the giving partner's tongue is immobilized during deep-throating and they are not able to suck ; the receiver's glans penis is intensely stimulated by the tightness of the giving partner's throat.
The device consists of a standard PLCC integrated circuit socket which has been turned upside-down in order to be placed directly over a microprocessor already permanently soldered to a printed circuit board in a receiver ; the socket makes electrical contact with all pins of the microprocessor and is interfaced to one or more microcontrollers which use direct memory access to pause the receiver's microprocessor and read or write directly to the memory.
; F: Half of the BANZSL " F " is signed either on the palm or on the top of the receiver's index finger
; T: BANZSL " T " is signed on the receiver's hand
Alpine was one of the first in the industry to introduce in-vehicle iPod devices to allow users to control iPod playback using the head unit's front panel buttons or remote ; view song information ( artist, album and / or song name ) on the display ; and easily search for songs through the receiver's Quick Searchinterface.

receiver's and are
Blind transmissions may occur or be necessary when security constraints, such as radio silence, are imposed, when technical difficulties with a sender's receiver or receiver's transmitter occur, or when lack of time precludes the delay caused by waiting for receipts.
A deceiver's actions are interrelated to the message receiver's actions.
As these systems are almost always used with a specific navigational chart with the hyperbolic lines plotted on it, they generally reveal the receiver's location directly, eliminating the need for manual triangulation.
Generic functions correspond roughly to what Smalltalk calls methods, with the notable exception that, in Smalltalk, the receiver's class is the sole determinant of which body of code is actually called: the types or values of the arguments are irrelevant ( single dispatch ).
Exceptionally strong signals are designated by the quantitative number of decibels, in excess of " S9 ", displayed on the receiver's S meter.
In professional USA licensed systems, Federal Communications Commission rules require CTCSS users on shared channels to disable their receiver's CTCSS to check if co-channel users are talking before transmitting.
" In theory, three satellites are required to position the receiver in three-dimensional space, however the receiver's clock will likely not be synchronized with the atomic clocks aboard the satellite, so a fourth pseudorange measurement is used to correct the receiver's clock bias.
If the satellites being used are scattered throughout the sky, then the value of geometric dilution of precision ( GDOP ) is low while if satellites are clustered near each other from the receiver's vantage point the GDOP values are higher.
Different manual alphabets may be used, such as the one-handed ASL alphabet ( the receiver places their hand over the back of the hand of the signer ) or the two-handed manual alphabet, which is often used in a form adapted for deafblind communication, known as the Deafblind alphabet, in which letters are produced onto palm of the receiver's hand.
* Reno: If three duplicate ACKs are received ( i. e., four ACKs acknowledging the same packet, which are not piggybacked on data, and do not change the receiver's advertised window ), Reno will halve the congestion window, perform a fast retransmit, and enter a phase called Fast Recovery.
In that case, the baseband audio ( recovered from the discriminator of the FM receiver before multiplex decoding or filtering ) is fed into the receiver's RF ( antenna ) input and the radio tuned to the subcarrier frequency ( typically between 53 and 94 kHz, 67 and 92 are common ) to extract the signal's contents.
This technique is extremely dangerous, as the receiver's arms are restrained and his / her head is not placed between the wrestler's legs, giving him / her little to post against.

receiver's and advantages
By the 1930s, improvements in vacuum tube technology rapidly eroded the TRF receiver's cost advantages, and the explosion in the number of broadcasting stations created a demand for cheaper, higher-performance receivers.

receiver's and at
* A pass is ruled complete if one of the receiver's feet is inbounds at the time of the catch.
This means signals must be received from at least three LORAN transmitters to pinpoint the receiver's location.
The varying current in the coil produces a corresponding movement of the receiver's diaphragm, reproducing the original sound waves present at the transmitter.
The telegraph receiver's operator would visually observe the bubbles and could then record the transmitted message, albeit at a very low baud rate.
Thus the figure of merit of a communications system is not the noise level at the speaker of a radio, for instance, since that depends on the setting of the receiver's gain.
* Unlike random noise, it must be easy to generate exactly the same sequence at both the transmitter and the receiver, so the receiver's locally generated sequence has a very high correlation with the transmitted sequence.
For a receiver, the attack-time delay is defined as the time interval from the instant a step radio-frequency ( RF ) signal, at a level equal to the receiver's threshold of sensitivity, is applied to the receiver input, to the instant when the receiver's output amplitude reaches 90 % of its steady-state value.
On the other hand, the White Pearl will have one vote subtracted from the count in the receiver's favor in the next Tribal Council, should at least one such vote comes up.
This system jammed the Straßburg receiver's intermediate frequency section, which operated at a 3 MHz frequency and appears to have been quite successful, especially as the operator did not have to attempt to find which of the 18 Kehl / Straßburg command frequencies were in use and then manually tune the jamming transmitter to one of those frequencies.
When a cornerback is attempting to jam or funnel a receiver, he is trying to disrupt the receiver's route at the line of scrimmage.
The rear sight is welded at the end of the receiver's dust cover.
RAIM availability is an important issue when using such kind of algorithm in safety-critical applications ( as the aeronautical ones ); in fact, because of geometry and satellite service maintenance, RAIM is not always available at all, meaning that the receiver's antenna could have sometimes less than five satellites in view.
The server SMTP at the receiver's side receives the NVT ASCII data and delivers it to MIME to be transformed back to the original non-ASCII data.
He currently serves as the receiver's coach at Petal High School localted in Petal, Mississippi, just across the Leaf River from Hattiesburg.
Trailing 17-3 after a Matt Stover field goal, Fiedler's 40-yard pass to James McKnight at the Ravens 5-yard line bounced off the receiver's shoulder and was intercepted by defensive back Duane Starks, who returned the ball 26 yards to the 28-yard line.
This is a level of 50 microvolts at the receiver's antenna input assuming the input impedance of the receiver is 50 ohms.
Pressing the directional button or left analog stick in a certain direction as you pass the ball will make the throw over the receiver's head ( Up ), behind him ( Left ), in front of him ( Right ), or at his knees ( Down ).

0.271 seconds.