Neglecting the wire resistance R and the leakage conductance G, this gives

Neglecting transmission line losses, the input impedance of the stub is purely reactive ; either capacitive or inductive, depending on the electrical length of the stub, and on whether it is open or short circuit.

Neglecting activities, the chemical equilibrium constant, K < sub > eq </ sub >, for this reaction is given by:

Neglecting the virtual temperature correction may result in substantial relative errors in the calculated value of CAPE for small CAPE values .< ref > CAPE may also exist below the LFC, but if a layer of CIN ( subsidence ) is present, it is unavailable to deep, moist convection until CIN is exhausted.

Neglecting the stochastic term for a moment, notice that the change in r is negative if r is currently " large " ( greater than θ ( t )/ α ) and positive if the current value is small.

Neglecting parents interact less with their children, engage in less verbal instruction and play behavior, show less affection and are involved in more negative interactions with their children, for example verbal aggression.

Neglecting the physical space needed for the initial acceleration, this technique doubles the effective period of weightlessness.

Neglecting atmospheric refraction, declination is always 0 ° at east and west points of the horizon.

Neglecting divergence due to poor beam quality, the divergence of a laser beam is proportional to its wavelength and inversely proportional to the diameter of the beam at its narrowest point.

Neglecting the slip correction, the terminal velocity at which the particle settles is proportional to the square of the aerodynamic diameter, d < sub > a </ sub >:

Neglecting atmospheric refraction and the Sun's non-zero size, whenever and wherever sunset occurs, it is always in the northwest quadrant from the March equinox to the September equinox, and in the southwest quadrant from the September equinox to the March equinox.

Neglecting the phase change due to the two reflections, the phase difference between the two beams is

Neglecting V < sub > BE </ sub >, the high threshold value is approximately

For example, Zen is known as the school of Buddhism that does not stand on written words and one caveat says, " Neglecting the written records with unrestrained ideas is falling into a deep pit.

: Neglecting the written records with unrestrained ideas is falling into a deep pit.

Neglecting possible multiple ionizations of the same atom, the number of created ions is the same as the number of created electrons:

Neglecting the contribution of the electrons to the mass density and assuming that there is a single ion species, we get

Neglecting the orthosilicate anions not involved in the redox process, it is then possible to schematically write the two half-redox reactions as follows:

Neglecting to give zakat can result in damnation in the afterlife, while those who give zakat can expect reward from God in the afterlife.

Neglecting phase space effects and higher order corrections, simple estimates of their branching fractions can be calculated from the coupling constants.

Neglecting electron correlation can lead to large deviations from experimental results.

Neglecting ionospheric and tropospheric effects, the signal from GPS satellites has a fixed precision.

Public indignation and resistance to wage-price increases is obviously much less when the increases are on the order of 3% per annum than when the increases are on the order of 3% per month.

where T ( R ) is the temperature of the thermistor as a function of its resistance R, is the temperature of the surroundings, and K is the dissipation constant, usually expressed in units of milliwatts per degree Celsius.

The sensitivity of such a meter can be expressed as " ohms per volt ", the number of ohms resistance in the meter circuit divided by the full scale measured value.

For example a meter with a sensitivity of 1000 ohms per volt would draw 1 milliampere at full scale voltage ; if the full scale was 200 volts, the resistance at the instrument's terminals would be 200, 000 ohms and at full scale the meter would draw 1 milliampere from the circuit under test.

The technical specifications of these devices were often crude, for example the one illustrated has a resistance of just 33 ohms per volt, a non-linear scale and no zero adjustment.

: is the resistance per unit length,

: is the series resistance of the line per unit length

* The distributed resistance of the conductors is represented by a series resistor ( expressed in ohms per unit length ).

Experiments have documented that olivine at high pressures ( e. g., 12 GPa, the pressure at depths of about 360 kilometers ) can contain at least as much as about 8900 parts per million ( weight ) of water, and that such water contents drastically reduce the resistance of olivine to solid flow ; moreover, because olivine is so abundant, more water may be dissolved in olivine of the mantle than contained in Earth's oceans.

* Series resistance per unit length, in ohms per metre.

The resistance per unit length is just the resistance of inner conductor and the shield at low frequencies.

Some scholars go as far as to claim that neither insulin resistance, nor obesity are really metabolic disorders per se, but simply adaptive responses to sustained caloric surplus, intended to protect bodily organs from lipotoxicity ( unsafe levels of lipids in the bloodstream and tissues ): " Obesity should therefore not be regarded as a pathology or disease, but rather as the normal, physiologic response to sustained caloric surplus ... As a consequence of the high level of lipid accumulation in insulin target tissues including skeletal muscle and liver, it has been suggested that exclusion of glucose from lipid-laden cells is a compensatory defense against further accumulation of lipogenic substrate.

Edward III's army left Poissy and marched north, estimates were that they covered several miles per day and met slight resistance by French allies of King John's army.

where is the length of the conductor, measured in metres, A is the cross-section area of the conductor measured in square metres, σ ( sigma ) is the electrical conductivity measured in siemens per meter ( S · m < sup >− 1 </ sup >), and ρ ( rho ) is the electrical resistivity ( also called specific electrical resistance ) of the material, measured in ohm-metres ( Ω · m ).

In a device without internal resistance, if an electric charge Q passes through that device, and gains an energy W, the net emf for that device is the energy gained per unit charge, or W / Q.

Though the process met some resistance, by 1215 the practice had become established as the norm, with the Fourth Lateran Council establishing a canonical statute requiring confession at a minimum of once per year.

Due to large stray capacitance ( from 2-25 pF per contact point ), high inductance of some connections and a relatively high and not very reproducible contact resistance, solderless breadboards are limited to operation at relatively low frequencies, usually less than 10 MHz, depending on the nature of the circuit.

* The inclusion of seven extra weapons per character, which have different designs and statistics, composed of Power ( inflicts more damage ), Defense ( receives less damage ), Strength ( damage dealt to enemy's weapon gauge ), Durability ( resistance of player's weapon gauge ) and Weight ( changes character's speed ).

Thermal conductivity is measured in watts-per-meter per kelvin ( W · m < sup >− 1 </ sup >· K < sup >− 1 </ sup >), represented as k. As the thickness of insulating material increases, the thermal resistance — or R-value — also increases.