Typical emulsions used in these techniques are nanoemulsions of soybean oil, with particles that are 400-600 nm in diameter.

Typical PCI cards used in PCs include: network cards, sound cards, modems, extra ports such as USB or serial, TV tuner cards and disk controllers.

Typical antipsychotics such as phenothiazines and haloperidol have been used to control psychotic symptoms, but may produce many undesirable side effects — such as dystonia — and their use is therefore no longer preferred ; phenothiazines are particularly risky, as they may lower the seizure threshold, worsen hyperthermia, and boost the anticholinergic effects of PCP.

Typical parameters would be 300-400 mV for < 1 ms across the membrane ( note-the voltages used in cell experiments are typically much larger because they are being applied across large distances to the bulk solution so the resulting field across the actual membrane is only a small fraction of the applied bias ).

Typical nuclear weapon yields used during Cold War planning for EMP attacks were in the range of 1 to 10 megatons ( 4. 2 to 42 PJ ) This is roughly 50 to 500 times the sizes of the weapons the United States used in Japan at Hiroshima and Nagasaki.

Typical measuring receivers used by EMC testing laboratories divide the electromagnetic spectrum into frequency bands approximately 120 kHz wide.

Typical values of Z < sub > 0 </ sub > are 50 or 75 ohms for a coaxial cable, about 100 ohms for a twisted pair of wires, and about 300 ohms for a common type of untwisted pair used in radio transmission.

Typical CT Scout view as used for planning an exam

Typical vegetable oils used in soap making are palm oil, coconut oil, olive oil, and laurel oil.

Typical machines of the era used a single CPU to drive the entire system.

Typical integration methods used in a discrete element method are:

Typical memory hierarchy ( access times and cache sizes are approximations of typical values used for the purpose of discussion ; actual values and actual numbers of levels in the hierarchy vary ):

Typical lines used, and their wavelengths, are as follows:

Typical serial ports used with personal computers connected to modems use eight data bits, no parity, and one stop bit ; for this configuration the number of ASCII characters per second equals the bit rate divided by 10.

Typical antenna sizes on C-band capable systems ranges from 7. 5 to 12 feet ( 2. 5 to 3. 5 meters ) on consumer satellite dishes, although larger ones also can be used.

Typical lunar transfer trajectories approximate Hohmann transfers, although low energy transfers have also been used in some cases, as with the Hiten probe.

Typical voltages used are + 5 V or + 3. 3 V although systems with other voltages are permitted.

Typical modern American football as used in the NFL

Typical diagnostic sonographic scanners operate in the frequency range of 2 to 18 megahertz, though frequencies up to 50 – 100 megahertz have been used experimentally in a technique known as biomicroscopy in special regions, such as the anterior chamber of the eye.

Typical F71T12 100 W bi-pin lamp used in tanning beds.

Typical fabrics used are velvet, silk and satin.

Typical levels of pectin used as a food additive are between 0. 5 and 1. 0 % – this is about the same amount of pectin as in fresh fruit.

Typical installations had a master unit ( supplying disk storage ) connected to intelligent diskless slaves which the operators used.

Typical set of three metal tire levers of the type used on bicycles

Typical touch: She sold a $10,000 morning light mink to Sportsman Freddie Wacker for his frau, Jana Mason, also an ex-singer.

Typical landscape for the Antarctic Peninsula area, with fjords, high coastal mountains and islands.

Typical values of V range from around 20 for very dense flint glass, around 30 for polycarbonate plastics, and up to 65 for very light crown glass, and up to 85 for fluor-crown glass.

Typical properties calculated for a flow field include velocity, pressure, density and temperature as a function of spatial position and time.

Typical of his satire and cynical humour, the book included a discourse on Parkinson's Law of Triviality ( debates about expenses for a nuclear plant, a bicycle shed, and refreshments ), a note on why driving on the left side of the road ( see road transport ) is natural, and suggested that the Royal Navy would eventually have more admirals than ships.

* Typical modern six-string classical guitars are 48 – 54 mm wide at the nut, compared to around 42 mm for electric guitars.

Typical bore size for low-speed engines ranges from approximately.

Typical training for a North American endocrinologist involves 4 years of college, 4 years of medical school, 3 years of residency, and 2 years of fellowship.

Typical equipment for a floorball player consists of a stick, a pair of shorts, a shirt, socks, and indoor sport shoes.

Typical monthly calendars that include phases of the moon may be off by one day if intended for use in a different time zone.

Typical adult limits for these hormones are: TSH ( units ): 0. 45-4. 50 uIU / mL ; T4 Free / Direct ( nanograms ): 0. 82-1. 77 ng / dl ; and T3 ( nanograms ): 71-180 ng / dl.

Typical rules concern restrictions on the availability of funds to retail investors ( Dublin ), protection of client confidentiality ( Luxembourg ) and the requirement for the fund to be independent of the fund manager.

Typical of her aggressive style was her victory against GM Georgi Kacheishvili in which she sacrificed her queen for the attack.

Typical set of vehicles for soviet missile systems is the following:

Typical and New South Wales koala weights are for males and for females.

Typical operating currents for such devices begin at 350 mA.

Typical input and output devices include switches, relays, solenoids, LEDs, small or custom LCD displays, radio frequency devices, and sensors for data such as temperature, humidity, light level etc.

Typical fission events release about two hundred million eV ( 200 MeV ) of energy for each fission event.

Typical conditions for the first stage, which contribute to an overall yield of about 96 %, are:

Typical radiosity methods only account for light paths of the form LD * E, i. e., paths which start at a light source and make multiple diffuse bounces before reaching the eye.

Typical concentration values fall somewhere in this range and are tailored to produce the desired properties in the device that the semiconductor is intended for.