* Analog signal processing, processing electronic signals that represent continuous variables by use of analog circuitry

Analog sequencers use CV / Gate signals to control pre-MIDI analog synthesizers.

Analog and digital modulation facilitate frequency division multiplexing ( FDM ), where several low pass information signals are transferred simultaneously over the same shared physical medium, using separate passband channels ( several different carrier frequencies ).

Analog signals are like volume controls, with a range of values between zero and full-scale.

Analog signal processing is for signals that have not been digitized, as in legacy radio, telephone, radar, and television systems.

Analog audio signals are susceptible to noise and distortion, due to the innate characteristics of electronic circuits and associated devices.

Analog signals that have not already been bandlimited must be passed through an anti-aliasing filter before conversion, to prevent the distortion that is caused by audio signals with frequencies higher than the Nyquist frequency, which is half of the system's sampling rate.

* Analog discs typically relying on a modulated groove to record signals

Analog ( or analogue ) recording ( Greek, ana is " according to " and logos " relationship ") is a technique used for the recording of analog signals which among many possibilities include audio frequency, analog audio and analog video information for later playback.

Analog recording methods store signals as a continual wave in or on the media.

* Analog multiplier, a device that multiplies two analog signals

Analog signals were gradually phased out, a process which lasted from 2002 to 2008.

Analog computer signals were used to drive 4 external rudders on the tail fins for flight control.

Legacy Analog TVs, whether color or monochrome, use continuous voltage signals which do not have a fixed number of different intensities, although the signals are subject to noise introduced in transmission.

Analog terrestrial TV signals require a processor which is a RF receiver that outputs video and audio.

Analog signals are continuously variable, both in the number of possible values of the signal at a given time, as well as in the number of points in the signal in a given period of time.

Analog signals are continuous electrical signals ; digital signals are non-continuous.

Analog signal processing is any signal processing conducted on analog signals by analog means.

Analog recording records analog signals only.

Analog Devices data converters include analog-to-digital converters ( ADCs ) and digital-to-analog converters ( DACs ) that convert electrical signal representations of real-world analog phenomena, such as light, sound, waveforms, temperature, motion, and pressure into digital signals or data, and back again.

Analog television may be wireless or can require copper wire used by cable converters.

Analog computers can have a very wide range of complexity.

Just inside the perforations, on the left side of the image, is the analog optical soundtrack, with two channels encoded using Dolby Analog SR | Dolby SR noise reduction that can be dematrixed into four channels using Dolby Pro Logic.

While the North American PSTN can use PRI or Analog T1 format from PBX to PBX, the POTS or BRI can be delivered to a business or residence.

North American PSTN can connect from PBX to PBX via Analog T1, T3, PRI, OC3, etc ...

Analog synthesizers that have no digital component and were built prior to MIDI's development can be retrofit with kits that convert MIDI messages into analog control voltages.

) Analog instruments are usually based on a microammeter whose pointer moves over a scale calibrated for all the different measurements that can be made ; digital instruments usually display digits, but may display a bar of a length proportional to the quantity being measured.

Analog meters are also useful in situations where its necessary to pay attention to something other than the meter, and the swing of the pointer can be seen without looking at it.

Analog meters can measure voltage and current using power from the test circuit but require internal power for resistance testing, electronic meters always require an internal power supply.

Analog studio master tapes using Dolby-A noise reduction can have a dynamic range of around 80 dB.

Analog audio's frequency response is less flat than digital, but it can vary in the electronics.

Analog or digital data such as transmitter power, temperature, VSWR, voltage, modulation level, and other status information are returned so that broadcast engineering staff can correct any problems as soon as possible.

Instrumentation amplifiers can be built with individual op-amps and precision resistors, but are also available in integrated circuit form from several manufacturers ( including Texas Instruments, National Semiconductor, Analog Devices, Linear Technology and Maxim Integrated Products ).

Analog multiplication can be accomplished by using the Hall Effect.

Analog recordings can be copied freely.

Analog signal can be converted to digital signal by ADC.

These access devices can range from small Analog Telephone Adaptors ( ATA ) which provide just one RJ11 telephone jack to an Integrated Access Device ( IAD ) or PBX which may provide several hundred telephone connections.

Many similar unscheduled MDxx chemicals can be prosecuted under the Federal Analog Act.

The pair gain unit which performs the multiplexing can be as simple as providing two telephone connections over a single subscriber line ( called an Analog Multi-Line Carrier or AML ) in circumstances where a customer wants to add a new phone line for a fax machine or dial-up internet connection.

Analog models are still susceptible to eavesdropping, However, older used models can still be found that are fully capable of receiving this spectrum.

Analog equivalents do exist and can provide longer reach, but with potential loss of confidentiality and voice quality.

Analog tuners can tune only analog signals.

As a result of Walsham, the Federal Analog Act has been upheld ( at least for the states and territories comprising the third judicial circuit ) and can be considered valid at the present time.