[permalink] [id link]
Asynchronous Transfer Mode ( ATM ) is, according to the ATM Forum, " a telecommunications concept defined by ANSI and ITU ( formerly CCITT ) standards for carriage of a complete range of user traffic, including voice, data, and video signals ," and is designed to unify telecommunication and computer networks.
from
Wikipedia
Some Related Sentences
Asynchronous and Transfer
# REDIRECT Asynchronous Transfer Mode
* Asynchronous Transfer Mode, telecommunications protocol used in networking
* Asynchronous Transfer Mode, a method of digital communication
At the Data Link Layer, multicast describes one-to-many distribution such as Ethernet multicast addressing, Asynchronous Transfer Mode ( ATM ) point-to-multipoint virtual circuits ( P2MP ) or Infiniband multicast.
The primary benefit is to eliminate dependence on a particular OSI model data link layer technology, such as Asynchronous Transfer Mode ( ATM ), Frame Relay, Synchronous Optical Networking ( SONET ) or Ethernet, and eliminate the need for multiple layer-2 networks to satisfy different types of traffic.
These are roughly comparable to IP addresses used in the Internet Protocol ; they can specify a piece of equipment connected to an Asynchronous Transfer Mode ( ATM ) network.
Circuit switched networks, especially those intended for voice transmission, such as Asynchronous Transfer Mode ( ATM ) or GSM, have QoS in the core protocol and do not need additional procedures to achieve it.
Frame Relay complements and provides a mid-range service between basic rate ISDN, which offers bandwidth at 128 kbit / s, and Asynchronous Transfer Mode ( ATM ), which operates in somewhat similar fashion to Frame Relay but at speeds from 155. 520 Mbit / s to 622. 080 Mbit / s.
The designated technology for B-ISDN was Asynchronous Transfer Mode ( ATM ), which was intended to carry both synchronous voice and asynchronous data services on the same transport.
Due to SONET / SDH's essential protocol neutrality and transport-oriented features, SONET / SDH was the obvious choice for transporting the fixed length Asynchronous Transfer Mode ( ATM ) frames also known as cells.
Both SONET and SDH can be used to encapsulate earlier digital transmission standards, such as the PDH standard, or they can be used to directly support either Asynchronous Transfer Mode ( ATM ) or so-called packet over SONET / SDH ( POS ) networking.
Many DSL technologies implement an Asynchronous Transfer Mode ( ATM ) layer over the low-level bitstream layer to enable the adaptation of a number of different technologies over the same link.
Later implementations often use Point-to-Point Protocol ( PPP ) or Asynchronous Transfer Mode ( ATM ) ( Point-to-Point Protocol over Ethernet ( PPPoE ) or Point-to-Point Protocol over ATM ( PPPoA )), while authenticating with a userid and password and using Point-to-Point Protocol ( PPP ) mechanisms to provide network details.
Asynchronous Transfer Mode is often the communications protocol used.
* Asynchronous Transfer Mode ( ATM ), where the circuit is identified by a virtual path identifier ( VPI ) and virtual channel identifier ( VCI ) pair.
* 176-Standardized Profile For Asynchronous Transfer Mode ( Atm )
Some technologies used for this purpose are Asynchronous Transfer Mode ( ATM ), FDDI, and SMDS.
Asynchronous Transfer Mode ( ATM ) also is a virtual circuit technology, which uses fixed-length cell relay connection oriented packet switching.
In Asynchronous Transfer Mode or packet switching applications, the crosspoints must be made and broken at each decision interval.
ARP has been implemented in many combinations of network and overlaying internetwork technologies, such as IPv4, Chaosnet, DECnet and Xerox PARC Universal Packet ( PUP ) using IEEE 802 standards, FDDI, X. 25, Frame Relay and Asynchronous Transfer Mode ( ATM ), IPv4 over IEEE 802. 3 and IEEE 802. 11 being the most common cases.
The proprietary protocol was based on Asynchronous Transfer Mode ( ATM ).
* AES47, Professional AES3-style digital audio over Asynchronous Transfer Mode networks
DSL modems provide Ethernet ( or Ethernet over USB ) connections to local equipment, but inside they are actually Asynchronous Transfer Mode ( ATM ) modems.
Over time, the CompuServe network evolved into a sophisticated multi-tiered network incorporating Asynchronous Transfer Mode, Frame relay, Internet Protocol and X. 25 technologies.
Asynchronous and Mode
* Asynchronous Balanced Mode, a communication mode of HDLC and derivative protocols
Asynchronous Balanced Mode ( ABM ) is a communication mode of HDLC and derivative protocols, supporting peer-oriented point-to-point communications between two nodes, where either node can initiate transmission.
Asynchronous and ATM
* Asynchronous Transfer Mode ( ATM )
Today, the term may refer not only to Frame Relay and Asynchronous Transfer Mode ( ATM ), both providing PVCs, but also to Internet Protocol ( IP ), GPRS, and other packet-switching techniques.
* Multiplex Section Protection, an Asynchronous Transfer Mode ( ATM ) link-protection 1 + 1 fail-over mechanism
Depending on its device architecture and setup, a DSLAM aggregates the DSL lines over its Asynchronous Transfer Mode ( ATM ), frame relay, and / or Internet Protocol network ( i. e., an IP-DSLAM using PTM-TC Transfer Mode-Transmission Convergence ) protocol ( s ) stack.
Traditional 20th century DSLAM used Asynchronous Transfer Mode ( ATM ) technology to connect to upstream ATM routers / switches.
Asynchronous and is
Asynchronous IPC is analogous to network communication: the sender dispatches a message and continues executing.
For systems that work in the ABM ( Asynchronous Balanced Mode ), there is no master / slave relationship.
A Universal Asynchronous Receiver / Transmitter, abbreviated UART (), is a type of " asynchronous receiver / transmitter ", a piece of computer hardware that translates data between parallel and serial forms.
HDLC can be used for point to multipoint connections, but is now used almost exclusively to connect one device to another, using what is known as Asynchronous Balanced Mode ( ABM ).
Asynchronous sequential logic is not synchronized by a clock signal ; the outputs of the circuit change directly in response to changes in inputs.
Asynchronous sequential circuits are typically used only in a few critical parts of otherwise synchronous systems where speed is at a premium, such as parts of microprocessors and digital signal processing circuits.
Typically, its interface is a WAN protocol such as Asynchronous Transfer Mode or Frame Relay.
Asynchronous serial communication describes an asynchronous, serial transmission protocol in which a start signal is sent prior to each byte, character or code word and a stop signal is sent after each code word.
Asynchronous start-stop is the physical layer used to connect computers to modems for many dial-up Internet access applications, using a data link framing protocol such as PPP to create packets made up out of asynchronous serial characters.
Point-to-Point Protocol over Asynchronous Transfer Mode ( PPPoA ) is specified in RFC 2364.
This technology is known as Asynchronous Flash and XML, much like AJAX.
The speed of remote surgery is made possible through ATM technology, or Asynchronous Transfer Mode.
“ Asynchronous Transfer Mode is a technology designed for the high-speed transfer of voice, video, and data through public and private networks using cell relay technology ”.
LAPB is essentially HDLC in Asynchronous Balanced Mode ( ABM ).
The campus is capable of offering video conferencing over ATM ( Asynchronous Transfer Mode ), ISDN ( Integrated Services Digital Network ), or via the Internet in H. 323 format.
Asynchronous meetings are an option when reflected input is required rather than instant spontaneous interaction.
0.312 seconds.