Because diesels do not have fuel in the cylinder before combustion is initiated, more than one bar ( 100 kPa ) of air can be loaded in the cylinder without preignition.

Because here gas in-and outlets are positioned at opposed ends of the cylinder, one can achieve uniflow scavenging, which, as in the four-stroke engine, is efficient over a wide range of engine speeds.

Because the image is first transferred, or offset to the rubber blanket cylinder, this reproduction method is known as offset lithography or offset printing.

Because of this, many modern large caliber hunting revolvers tend to be based on the fixed cylinder design.

Because of this, the engine sported an unusual 90 ° angle between cylinder banks — a trait shared with the later PRV V6.

Because each cylinder on a radial engine has its own head, it is impractical to use a multivalve valvetrain on a radial engine.

Because the valve stem extends into lubrication in the cam chamber, it must be sealed against blow-by to prevent cylinder gases from escaping into the crankcase, even though the stem to valve clearance is very small, typically 0. 04-0. 06 mm.

Because of the difference in burn rates between the two different fuels, petrol engines are mechanically designed with different timing than diesels, so to auto-ignite a petrol engine causes the expansion of gas inside the cylinder to reach its greatest point before the cylinder has reached the " top dead center " ( TDC ) position.

Because of the way detonation breaks down the boundary layer of protective gas surrounding components in the cylinder, such as the spark plug electrode, these components can start to get very hot over sustained periods of detonation and glow.

Because the air inside the suit is compressed as the diver descends, a modern diving dry suit also has a gas inflation valve, which lets the diver control the buoyancy of the suit by injecting gas from a diving cylinder to avoid the suit from being squeezed tightly and painfully onto the diver's body during descent.

Because each individual cylinder requires its own control channel, the original Audio-Animatronic figures were relatively simple in design, to reduce the number of channels required.

Because the new pushrods also served to provide oil to the top of the cylinder head, the rockers were changed to the AMC-style, stud-mounted type.

Because of the cylinder arrangement in the VR6-with two rows of combustion chambers within the same cylinder head, the intake and exhaust ports between the two rows of cylinders are of varying lengths.

Because the piston assembly only moves in one dimension ( unlike the case in an engine with connecting rods ), contact with the cylinder wall is minimised, which reduces wear and lubrication requirements.

Because of this, many drives still have a surplus of sectors ( less than 1 cylinder in size ) at the end of the drive, since the total number of sectors rarely, if ever, ends on a cylinder boundary.

Because all of the mold and material factors are the same for n. If a cylinder is chosen for the geometry of the riser and the height to diameter ratio is locked, then the equation can be solved for a diameter, which makes this method a simple way to calculate the minimum size for a riser.

Because the trigger mechanism did not rotate the cylinder, shots were smooth and consistent, permitting rapid and accurate shooting.

Because more than one god bore the title " Baʿal " and more than one goddess bore the title " Baʿalat " or " Ba ` alah ," only the context of a text can indicate of which Baʿal ' lord ' or Baʿalath ' Lady ' a particular inscription or text is speaking.

Because of this design, having no significant movement of heavy mechanical parts during the firing cycle, the recoil produced is only the ' true ' recoil, equivalent to the equal and opposite reaction to the pellet and air volume's acceleration up the bore.

Because she bore a resemblance to the star, Jane Wyman, her father asked if she would mind also doubling for Wyman in the scenes that required " danger driving ".

Because of the similarity his name bore to " veterinary ", he endured the nickname of Dog-botherer ( which is also a play off " god-botherer ").

Because the rear fins have to have the same diameter as the gun bore, they typically are larger than is optimum for flight performance.

Because he is tall and bore a passing resemblance to Osama bin Laden, he was often used as a decoy when Bin Laden traveled.

Because of the slow movement of Dora, wind and flooding were major dangers as some areas bore the brunt of the storm for several hours and in some places up to a day.

Because of the school the square bore the name " Schulhof " as it was a schoolyard at that time.

Because of a lower bore axis, lighter slide, and locked breech, the Remington 53 boasted much less felt recoil than the M1911.

Because they are formed from two subunits of non-equal size, they are slightly longer in the axis than in diameter.

Because of its small seeds ( less than 1 mm diameter ), a handful is enough to sow a large area.

Because they could be tens of meters in diameter and several metres deep, landowners often did not make the effort of filling them up.

Because of the complexity and cost of building a telescope of this unprecedented size, ESO has elected to focus on the 39-meter diameter European Extremely Large Telescope instead.

Because TAPS hoped to begin laying pipe by September 1969, substantial orders were placed for steel pipeline 48 inches ( 122 cm ) in diameter.

Because of the depth of the line, most underground stations on this line ( except Admiralty, Shau Kei Wan and Tai Koo ) have curved walls on the platforms, which are due to the routes ' cylindrical tunnels, only with a greater diameter.

Because there are also small gaps between the strands, a stranded wire will always have a slightly larger overall diameter than a solid wire with the same AWG.

Because of the way the stick is held and its relatively thin diameter, blows to the groin are very frequent and difficult to block.

Because the wire was pulled past the head by the take-up spool, the actual wire speed slowly increased as the effective diameter of the take-up spool increased.

Because of the relatively small 1. 37 " ( 36 mm for shells threaded to the Italian standard ) diameter shell, designs that place the bearings inside the shell can either have large bearings and a thinner spindle, which lacks stiffness, or smaller bearings and a thicker spindle ( such as the original Shimano Octalink ), which is stiff but less durable.

Because of their higher gold content, and greater striking pressure, the coins were 27 mm wide and 4 mm deep ( the same diameter as a gold eagle ), rather than the 34 by 2 usual for double eagles and bullion coins.

Because the kalaleng is long and has a narrow internal diameter, it is easy to play different harmonics through overblowing — even with the rather weak force of the air from one nostril.

Because there are no roads on inhabited Fire Island, fire department vehicles are heavily modified four wheel drive with suspension lift, large diameter off-road tires and recovery equipment, which allow them to traverse the sometimes washed-out, loose sand.

Because considerable erosion has occurred since the Sudbury event, an estimated in the North Range, it is difficult to directly constrain the actual size of the Sudbury crater, whether it being the diameter of the original transient cavity, or the final rim diameter.

Because of its very wide field of view, it is very large and cumbersome — weighing and having a diameter of.

Because of foreshortening, it may be quite different from the actual physical diameter for an object that is seen under an angle.

Because of the detail work involved, airbrushes with a small tip diameter are considered more useful.

: Because of pitch rotation at take off, propeller diameter may have to be reduced ( with a loss of efficiency ) and / or landing gear made longer and heavier.

Because of the larger diameter rim (. 522 inches ) on the S & W cartridge, the rims would sometimes interfere with each other when attempting to load every chamber of a. 45 Colt chambered revolver.

Because of this, the Frankford Arsenal produced the. 45 M1877 Military Ball Cartridge which was identical to the S & W cartridge but had a slightly smaller rim diameter of. 512 inches ( identical to the rim of the. 45 Colt cartridge ) which could be used in either the Colt or the S & W revolvers.

Because only a limited number of holes could be made in the disks, and disks beyond a certain diameter became impractical, image resolution on mechanical television broadcasts was relatively low, ranging from about 30 lines up to 120 or so.

Because peening demands well-graded shot of consistent hardness, diameter, and shape, a mechanism for removing shot fragments throughout the process is desirable.