Because this range of non-zero amplitude may be very broad or infinite, this definition is typically relaxed so that the bandwidth is defined as the range of frequencies in which the signal's spectral density is above a certain threshold relative to its maximum.

Because subwoofers are generally limited to a bandwidth of no higher than 150 Hz, the switching speed for the amplifier does not have to be as high as for a full range amplifier, and simpler designs could be utilized.

Because the color information was designed to be a cheap, backwards compatible addition to the monochrome signal, the color signal has a lower bandwidth than the luminance signal, and hence lower horizontal resolution.

Because most WorldForge servers are run by volunteers without strong bandwidth and hardware capacities this direction also has practical reasons.

Because of the larger bandwidth required, NBFM is much more commonly used for VHF communication.

Because of the bandwidth taken up by the sidebands, the range allocated for the band as a whole is usually about 5 kHz wider on either side.

Because of the low bandwidth available it is not possible to transmit audio signals, therefore all messaging is done with alphanumeric data at very low bit rates.

Because the human visual system is less sensitive to the position and motion of color than luminance, bandwidth can be optimized by storing more luminance detail than color detail.

Because only one device may be transmitting at any one time, total network bandwidth is shared among all devices.

Because the low-frequency effects channel requires only a fraction of the bandwidth of the other audio channels, it is referred to as the ". 1 " channel ; for example " 5. 1 " or " 7. 1 ".

Because in normal networking situations all individual connections are treated equally, rather than actual file transfers, multiple connections yields an advantage on saturated links over simple connections, both in terms of total bandwidth allocation and resilience.

Because a DSC signal uses a stable signal with a narrow bandwidth and the receiver has no squelch, it has a slightly longer range than analog signals, with up 25 percent longer range and significantly faster.

Because HDTV requires more bandwidth, some transponders on Nimiq 2 will typically broadcast only 4-5 channels.

Because UHF spare bandwidth was very scarce, HD-MAC was usable " de facto " only to cable and satellite providers, where there bandwidth was less constricted.

Because of the narrow bandwidth of this band, VLF radio signals cannot carry audio ( voice ), and only transmit text messages at a slow data rate.

Because RPR strips the signal once it reaches the destination ( unlike a SONET UPSR / SDH SNCP ring, in which the bandwidth is consumed around the entire ring ) it can reuse the freed space to carry additional traffic.

Because of its low bandwidth requirements, G. 729 is mostly used in Voice over Internet Protocol ( VoIP ) applications where bandwidth must be conserved, such as conference calls.

( Because at least one of the channels was broadcast in monochrome, in theory it could be broadcast with a third of the bandwidth of a color channel ; blank screens and slideshows take up even less space, which could in theory account for the unusually high number of channels.

Because of this, the memory controller buffers data sent from the DRDRAM channels so the extra bandwidth can be utilised by the CPU.

Because the address portion of each bus cycle can not transfer data, the use of block mode meant fewer address cycles and more time for data cycles, allowing increased bus data transfer bandwidth.

Because memory modules have multiple internal banks, and data can be output from one during access latency for another, the output pins can be kept 100 % busy regardless of the CAS latency through pipelining ; the maximum attainable bandwidth is determined solely by the clock speed.

Because of this, the TCP acceleration software must provide its own mechanisms to ensure the reliability of the link, taking the latency and bandwidth of the link into account, and both ends of the high latency link must support the method used.

Because the cytochromes ( as well as other complexes ) are held within membranes in an organized way, the redox reactions are carried out in the proper sequence for maximum efficiency.

Because of the greater size and relative efficiency of the Salvadoran and Guatemalan industrial sectors, however, Honduras bought far more manufactured products from its neighbors than it sold to them.

Because of the enormous military successes of the Roman Republic and the Roman Empire, the legion has long been regarded as the prime ancient model for military efficiency and ability.

Because of its efficiency as a working breed, most huskies are bred to be able to withstand long work days on little amounts of food.

Because they convert electricity into laser light with much higher efficiency, diode lasers also run cooler, which in turn allows them to be operated at much higher frequencies.

Because of their fuel efficiency major motorhome manufacturer Thor Motor Coach made several Class C and Class A Motorhomes available on the Dodge Sprinter Chassis including their popular Four Winds Siesta & Chateau Citation product lines.

Because of their lower efficiency and larger bulk, air cycle coolers are not often used nowadays in terrestrial cooling devices.

Because of the aerodynamic efficiency of propellers and fans, it is more fuel efficient to accelerate a large mass by a small amount.

Because the internal rate of return is a rate quantity, it is an indicator of the efficiency, quality, or yield of an investment.

Because of the improved access and efficiency brought by the interstate system, especially Interstate 65, new development in the form of subdivisions and shopping centers located near these roads.

* Higher acceleration rate — Because of the energy efficiency, higher power-to-weight ratio and higher adhesive-weight-to-total-weight ratio values, MUs generally have higher acceleration ability than locomotive-type trains and are favored in urban trains and subway ( metro ) systems for frequent start / stop routines.

Because of their low efficiency, ADAFs are much less luminous than the Shakura-Sunyaev thin discs.

Because of the low efficiency of light output and a single point of failure ( filament burnout ) municipalities are increasingly retrofitting traffic signals with LED arrays

Because their speed over the ground is greater, this decrease in efficiency is less than proportional to speed until well above Mach 2, and the consumption per mile is lower.

Because the quantum efficiency of Hubble's detectors is quite low at 300 nm, the noise in observations at this wavelength is primarily due to CCD noise rather than sky background ; thus, these observations could be conducted at times when high background noise would have harmed the efficiency of observations in other passbands.

Because the regulated voltage of a linear regulator must always be lower than input voltage, efficiency is limited and the input voltage must be high enough to always allow the active device to drop some voltage.

Because of a Schottky diodes ’ low forward voltage drop, less energy is wasted as heat making them the most efficient choice for applications sensitive to efficiency.

Because of this, even a blower running at low efficiency will still mechanically deliver the intended volume of air to the engine, but that air will be hotter.

Because air pressure decreases at high altitudes, air compression is necessary in order to keep the airplane ’ s engine running at maximum efficiency.

Because centrifugal superchargers utilize centrifugal forces to compress the air, they offer higher efficiency than positive displacement designs, both in terms of power consumption and heat production.

Because of its fuel efficiency and high heat output, the pressurized burner stove remains in wide use to the current day.

Because of their efficiency, he soon preferred sugar beets.

Because fixed grip lifts move faster than detachables at load and unload, misloads ( and missed unloads ) are more frequent on fixed grips, and can reduce the efficiency as low as 80 %.