Help


[permalink] [id link]
+
Page "Bode plot" ¶ 97
from Wikipedia
Edit
Promote Demote Fragment Fix

Some Related Sentences

For and amplifier
For example, an audio amplifier with a gain given as 20 dB will have a voltage gain of ten ( but a power gain of 100 would only occur in the event the input and output impedances were identical ).
For example, a transconductance amplifier has a gain with units of conductance ( output current per input voltage ).
For every watt delivered to the load, the amplifier itself will, at best, dissipate another watt.
For visual effect they were " miked " by the sound crew, just as a real amplifier would be.
For slightly less flexibility in upgrades, a preamplifier and a power amplifier in one box is called an integrated amplifier ; with a tuner, it is a receiver.
For example, in a non-inverting amplifier ( see the figure on the right ) adding a negative feedback via the voltage divider R < sub > f </ sub >, R < sub > g </ sub > and the differential to single ended conversion is completed without gain losses.
For applications in flash ADCs the distributed signal across eight ports matches the voltage and current gain after each amplifier, and resistors then behave as level-shifters.
For example, the non-uniform frequency response curve of AC-coupled cascade amplifier is an example of frequency distortion.
For a Pockels cell, it is usually hundreds or even thousands of volts, so that a high-voltage amplifier is required.
For instance, assume an amplifier has a noise temperature 870 K and thus a noise figure of 6 dB.
For example, in a push-pull power amplifier using vacuum tubes, the signal is most often split by a phase splitter ( aka phase inverter ) stage which produces two signals, one in phase, and the other out of phase, that is, phase inverted.
For example, it is sometimes possible to use a lock-in amplifier to modulate and confine the signal within a very narrow bandwidth and then filter the detected signal to the narrow band where it resides, thereby eliminating most of the broadband noise.
For example, there are CMOS operational amplifier ICs available in the market.
For some years following the introduction of solid state amplifiers, their perceived sound did not have the excellent audio quality of the best valve amplifiers ( see valve audio amplifier ).
For an operational amplifier two resistors forming a voltage divider may be used for the feedback network to set β between 0 and 1.
For example, an op amp ( voltage amplifier ) can be arranged to make a current amplifier instead.
For older models of telephones, the headset microphone impedance is different from that of the original handset, requiring a telephone amplifier for the telephone headset.
For example, a subwoofer rated at 100 watts may be able to handle 100 watts of power at 80 hertz, but at 25 hertz it might not be able to handle nearly as much power since such frequencies would, for some drivers in some enclosures, force the driver beyond its mechanical limits much before reaching 100 watts from the amplifier.
For instance, an amplifier ( especially a surround sound receiver ), may be rated at 1, 000 watts peak power, but the harmonic distortion level might be 10 percent under those conditions.
For example, at 2 volts input, a typical audio amplifier might put out 20 V, meaning the linear gain is 10 V / V.
For conventional loudspeaker drivers, this essentially involves ensuring that the output impedance of the amplifier is close to zero and that the speaker wires are sufficiently short and have sufficiently large diameter.
For large concert venues, performers may also use an amplifier " head " with several separate speaker cabinets ( which usually contain two or four 12 " speakers ).

For and Figure
For example, arrow 17 in Figure 3 portrays the proximal radial epiphysis for boy 34, whereas the same epiphysis for girl 2 is portrayed by arrow 18 in Figure 4.
For the initial development an oxidation pond was constructed as shown in Figure 1.
For example, " Figure 7b " goes before " Figure 11a ", even though ' 7 ' comes after ' 1 ' in Unicode.
For a bonding MO with σ-symmetry, the orbital can be labeled σ < sub > g </ sub >, and for an antibonding MO with σ-symmetry the orbital can be labeled σ < sub > u </ sub >, because inversion through the center of symmetry for Figure 4 ( b ) would produce a sign change.
For a bonding MO with π-symmetry the orbital can be labeled π < sub > u </ sub > because inversion through the center of symmetry for Figure 5 ( c ) would produce a sign change.
For the circuit in Figure 2, in the stable state Q1 is turned off and Q2 is turned on.
For example, we see in Figure 170 that the married worker earning $ 95, 000 is estimated to get net benefits of $ 393, 000, while the single worker earning $ 5, 000 is estimated to get $ 277, 000.
For instance ( see Figure 1 ), consider the optimization problem
For one illustration of the apparent effect of surface termination on electron emission, see Figure 3 in Marchywka Effect.
Figure 2-A schematic representation of folk psychology of belief, desire, intention, and action .. For example, an observer watching Jim ’ s hand grasp the bottom of a basket and move his arm such that the basket is lifted off the table, the observer understands that the moving of the basket from its current position is an intentional action that Jim initiated ; a deduction that can be categorized as a reached via “ common sense ”.
For example, see Figure 1.
For example, the graphical model in the Figure shown above consists of the random variables
For example, the circuit in Figure 3 has an of and a of.
For example, if glucose and lactose were both provided, glucose was metabolized first ( growth phase I, see Figure 2 ) and then lactose ( growth phase II ).
For longitudinal phonons in a string of atoms the dispersion relation of the kinetic energy in a 1-dimensional k-space, as shown in Figure 2, is given by
For Figure 3, a large op amp gain achieves the maximum R < sub > out </ sub > with only a small R < sub > E </ sub >.
For some time Valentine had been wearing a shin guard, which he would rotate ( so it covered his calf, not his shin ) in order to increase the pressure exerted by the Figure Four Leglock.
For the U. S. Figure Skating Association, it refers to a skill level, while the International Skating Union uses it to designate age.
For example, in Figure 1, the middle peak is a subpeak of the right peak, which is in turn a subpeak of the left peak, which is the highest point on its landmass.
For each player there are five possible best response shapes, shown in Figure 6.
For simple periodic loadings, such as Figure 1, rainflow counting is unnecessary.
For Season 3 ( Fall 1998 ), the series became Figure It Out: Family Style, featuring two or three contestants who were related, typically parent-child or siblings.

0.248 seconds.