If word classes differ in their resistance or liability to stem replacement within meaning slot, it is conceivable that individual meanings also differ with fair consistence trans-lingually.

If a bacterium carries several resistance genes, it is called multidrug resistant ( MDR ) or, informally, a superbug or super bacterium.

If the resistant pest is feeding in the non-Bt corn nearby, the resistance is neutral and offers no advantage to the pest over any nonresistant pest.

If light pressure were the cause of the rotation, then the better the vacuum in the bulb, the less air resistance to movement, and the faster the vanes should spin.

If a nation continues on this path without resistance, Gini claimed the nation would enter a final decadent stage where the nation would degenerate as noted by decreasing birth rate, decreasing cultural output, and the lack of imperial conquest.

If such an extraordinary event had actually taken place ... could the king have withstood the attitude of the native nobles, who would hardly have looked upon such an occurrence without offering armed resistance to their feeble and capricious sovereign?

If the depletion region expands to completely close the channel, the resistance of the channel from source to drain becomes large, and the FET is effectively turned off like a switch.

If water is evaporated too quickly, the membrane dries, resistance across it increases, and eventually it will crack, creating a gas " short circuit " where hydrogen and oxygen combine directly, generating heat that will damage the fuel cell.

If an inductor is connected to a direct current source with value I via a resistance R, and then the current source is short-circuited, the differential relationship above shows that the current through the inductor will discharge with an exponential decay:

If this binding energy is higher than the energy provided by kicks from oscillating atoms in the conductor ( which is true at low temperatures ), then the electron pair will stick together and resist all kicks, thus not experiencing resistance.

If the voltage is zero, this means that the resistance is zero.

If the collector voltage were zero, the collector current would be limited only by the light bulb resistance and the supply voltage.

If ' is positive, the resistance increases with increasing temperature, and the device is called a positive temperature coefficient ( PTC ) thermistor, or posistor.

If ' is negative, the resistance decreases with increasing temperature, and the device is called a negative temperature coefficient ( NTC ) thermistor.

If the current is large enough to generate more heat than the device can lose to its surroundings, the device heats up, causing its resistance to increase, and therefore causing even more heating.

If all four resistor values and the supply voltage () are known, and the resistance of the galvanometer is high enough that is negligible, the voltage across the bridge () can be found by working out the voltage from each potential divider and subtracting one from the other.

If one drops a ball at any given point on a ski run, the ball will be pulled down the hill by gravity and follow a path of least resistance known as the " fall line ".

If the power supply and ground wires have significant resistance, the voltage drop across them may create noise voltage pulses in the ground wires, which are applied to other parts of the circuit, The large capacitance of the ground plane allows it to absorb the current pulses without much change in voltage,

If the current J is alternating because the applied voltage or E-field varies in time, then reactance must be added to resistance to account for self-inductance, see electrical impedance.

If a conductor has significant resistance, then, near the surface of that conductor, the Poynting vector would be tilted toward and impinge upon the conductor.

If it is desirable to plate one type of deposit onto a metal to improve corrosion resistance but this metal has inherently poor adhesion to the substrate, a strike can be first deposited that is compatible with both.

If insulin resistance exists, more insulin needs to be secreted by the pancreas.

If Stoke's law holds then the resistance to motion is directly proportional to speed.

12 to General Sir H. Rawlinson, 16 June 1916 Stating the Objectives ') and that preparations should be made for an advance of to Bapaume should German resistance crumble, " If the first attack goes well every effort must be made to develop the success to the utmost by firstly opening a way for our cavalry and then as quickly as possible pushing the cavalry through to seize Bapaume ...." ( Note O. A. D.

If the pipes are the same size and shape, the pipe full of sand has higher resistance to flow.

If a child watched its progress he whispered, `` Hay, hay, load of hay -- make a wish and turn away '', and then stared rigidly in the opposite direction until the sound of the horses' feet returned no more.

If a DFS ROM is installed, will cause the computer to search for and load a file called on the floppy disk in drive 0.

If the pawl were held away from the sleeve the clutch would continue to drive the load without slipping.

If the column load is gradually increased, a condition is reached in which the straight form of equilibrium becomes so-called neutral equilibrium, and a small lateral force will produce a deflection that does not disappear and the column remains in this slightly bent form when the lateral force is removed.

If the axial load on the column is not concentric, that is, its line of action is not precisely coincident with the centroidal axis of the column, the column is characterized as eccentrically loaded.

If the rope and pulley system does not dissipate or store energy, then its mechanical advantage is the number of parts of the rope that act on the load.

If there are p of these parts of the rope supporting the load W, then a force balance on the moving block shows that the tension in each of the parts of the rope must be W / p.

If the overload senses excess current in the load, the coil is de-energized.

If a load is connected to the secondary winding, current will flow in this winding, and electrical energy will be transferred from the primary circuit through the transformer to the load.

If a load is connected to the secondary winding, the load current and voltage will be in the directions indicated, given the primary current and voltage in the directions indicated ( each will be alternating current in practice ).

If the secondary coil is attached to a load that allows current to flow, electrical power is transmitted from the primary circuit to the secondary circuit.

If there is no active partition, or the active partition's boot sector is invalid, the MBR may load a secondary boot loader which will select a partition ( often via user input ) and load its boot sector, which usually loads the corresponding operating system kernel.

If the power transmitted to the load before insertion is P < sub > T </ sub > and the power received by the load after insertion is P < sub > R </ sub >, then the insertion loss in dB is given by,

If a purely resistive load is connected to a power supply, current and voltage will change polarity in step, the power factor will be unity ( 1 ), and the electrical energy flows in a single direction across the network in each cycle.

If a load had a capacitive value, inductors ( also known as reactors in this context ) are connected to correct the power factor.

If the total allowable REN load is exceeded, the phone circuit may fail to ring or otherwise malfunction.

If the standing end goes through the loop, it will close under load.

If correct load capacitance is estimated on a node together with its activity factor, the dynamic power dissipation at that node can be calculated effectively.

If PC is a binary counter, it may increment when a pulse is applied to its COUNT UP input, or the CPU may compute some other value and load it into PC by a pulse to its LOAD input.

If the load balancer is replaced or fails, this information may be lost, and assignments may need to be deleted after a timeout period or during periods of high load to avoid exceeding the space available for the assignment table.