[permalink] [id link]
Q1 is considerably shorter than Q2 or F1 and may be a memorial reconstruction of the play as Shakespeare's company performed it, by an actor who played a minor role ( most likely Marcellus ).
from
Wikipedia
Some Related Sentences
Q1 and is
The show is being cast through the Bud United Facebook page and will air in Q1 2012.
Yet Q1 has value: it contains stage directions that reveal actual stage practices in a way that Q2 and F1 do not ; it contains an entire scene ( usually labelled 4. 6 ) that does not appear in either Q2 or F1 ; and it is useful for comparison with the later editions.
The major deficiency of Q1 is in the language: particularly noticeable in the opening lines of the famous " To be, or not to be " soliloquy: " To be, or not to be, aye there's the point.
Another theory, considered by New Cambridge editor Kathleen Irace, holds that Q1 is an abridged version intended especially for travelling productions.
The idea that Q1 is not riddled with error but is instead eminently fit for the stage has led to at least 28 different Q1 productions since 1881.
State 1 ( Q1 is switched on, Q2 is switched off ):
Q1 is on and connects the left-hand positive plate of C1 to ground.
Simultaneously, C2 that is fully discharged and even slightly charged to 0. 6 V ( in the previous State 2 ) quickly charges via the low-resistive collector resistor R4 and Q1 forward-biased base-emitter junction ( because R4 is less than R2, C2 charges faster than C1 ).
Q1 is firmly saturated in the beginning by the " forcing " C2 charging current added to R3 current ; in the end, only R3 provides the needed input base current.
The resistance R3 is chosen small enough to keep Q1 ( not deeply ) saturated after C2 is fully charged.
State 2 ( Q1 is switched off, Q2 is switched on ):
As its left-hand negative plate is connected to Q1 base, a maximum negative voltage (- V ) is applied to Q1 base that keeps Q1 firmly off.
Q1 and than
This results in more than half + V volts being applied to R4 causing current into the base of Q1, thus keeping it on.
Although Richard III was entered into the Register of the Stationers Company on 20 October 1597, by the bookseller Andrew Wise, who published the first quarto ( Q1 ) later that year ( with printing done by Valentine Simmes ), Christopher Marlowe's Edward II, which cannot have been written much later than 1592 ( Marlowe died in 1593 ) is thought to have been influenced by it.
Thus less current flows through and less voltage drop is across R < sub > E </ sub > when Q1 is switched on than in the case when Q2 is switched on.
For comparison, the Q1 apartment tower on the Gold Coast has its highest habitable floor the observation deck, reaching a height of, some lower than Eureka Tower's highest habitable floor.
During the war years Brighton works built more than half of Bulleid's Q1 class 0-6-0 freight locomotives, and the drawing office was primarily responsible for the detailed designs of his revolutionary Merchant Navy 4-6-2 express passenger locomotives, although the locomotives were built at Eastleigh Works.
Q1 and Q2
The calendar year can be divided into 4 quarters, often abbreviated Q1, Q2, Q3 and Q4:
Three different early versions of the play are extant, the First Quarto ( Q1, 1603 ), the Second Quarto ( Q2, 1604 ), and the First Folio ( F1, 1623 ).
* ISE — Internet Shakespeare Editions: transcripts and facsimiles of Q1, Q2 and F1.
Q2 collector voltage begins falling ; this change transfers through the fully charged C2 to Q1 base and Q1 begins cutting off.
Thus the initial input change circulates along the feedback loop and grows in an avalanche-like manner until finally Q1 switches off and Q2 switches on.
Looking at C2, just before Q2 turns on the left terminal of C2 is at the base-emitter voltage of Q1 ( V < sub > BE_Q1 </ sub >) and the right terminal is at V < sub > CC </ sub > (" V < sub > CC </ sub >" is used here instead of "+ V " to ease notation ).
For the circuit in Figure 2, in the stable state Q1 is turned off and Q2 is turned on.
It is triggered by zero or negative input signal applied to Q2 base ( with the same success it can be triggered by applying a positive input signal through a resistor to Q1 base ).
Hence, when the circuit is switched on, if Q1 is on, its collector is at 0 V. As a result, Q2 gets switched off.
For example, if Q2 is on and Set is grounded momentarily, this switches Q2 off, and makes Q1 on.
Oxfordian researchers believe that the play is an early version of Shakespeare's own play, and point to the fact that Shakespeare's version survives in three quite different early texts, Q1 ( 1603 ), Q2 ( 1604 ) and F ( 1623 ), suggesting the possibility that it was revised by the author over a period of many years.
After the publication of the Q1 and Q2 Hamlet in 1603, regular new play publication ceased for almost five years ( three new plays were issued in 1608 and 1609, the last ones until 18 plays made their publication debut in the First Folio of 1623 ).
All references to Romeo and Juliet, unless otherwise specified, are taken from the Arden Shakespeare second edition ( Gibbons, 1980 ) based on the Q2 text of 1599, with elements from Q1 of 1597.
This raises the equilibrium quantity from < tt > Q1 </ tt > to the higher < tt > Q2 </ tt >.
The equilibrium quantity increases from < tt > Q1 </ tt > to < tt > Q2 </ tt > as consumers move along the demand curve to the new lower price.
Comparison of the ' To be, or not to be ' soliloquy in the first three editions of Hamlet, showing the varying quality of the text in the Hamlet Q1 | Bad Quarto ( Q1 ), the Good Quarto ( Q2 ) and the First Folio
The publications of the latter are usually abbreviated to Q1, Q2, etc., where the letter stands for " quarto " and the number for the first, secord, or third edition published.
Q1 and F1
References to the First Quarto and First Folio are marked Hamlet Q1 and Hamlet F1, respectively, and are taken from the Arden Shakespeare " Hamlet: the texts of 1603 and 1623 " ( Thompson and Taylor, 2006b ).
For the most part, the adaptation followed Q1 exactly ( and F1 for 3. 2 ) with some minor alterations.
Q1 and may
While the exact relationship of the short and apparently primitive text of Q1 to the later published texts is not resolved, Hardin Craig among others has suggested that it may represent an earlier draft of the play and hence would confirm that the play referred to in 1589 is in fact merely an earlier draft of Shakespeare's play.
While the exact relationship of the short and apparently primitive text of Q1 to the later published texts is not resolved, Hardin Craig among others has suggested that it may represent an earlier draft of the play and hence would confirm that the " Ur-Hamlet " is in fact merely an earlier draft of Shakespeare's play.
Q1 or Q-1 may refer to:
Eventually, the players may discover an astral gate leading to the plane of the Abyss, leading into the Q1 module.
Q1 and be
Q1 of Henry V is a " bad quarto ", a shortened version of the play that might be a pirated copy or reported text.
Mack posits that Q1 itself can be broken into two historical stages, the first being simple maxims containing the core of the teachings, and the later stage being developments by the community giving illustrations and arguments for these maxims.
G. R. Hibbard argues that the name was originally Polonius, but was changed because Q1 derives from a version of the play to be performed in Oxford and Cambridge, and the original name was too close to that of Robert Polenius, founder of Oxford university.
The IEEE 1901 includes HomePlug AV as a baseline technology, so any IEEE 1901 products are fully interoperable with HomePlug AV, HomePlug Green PHY or the forthcoming HomePlug AV2 specification ( under development now and expected to be approved in Q1 2011 ).
This configuration can be considered as a differential amplifier with series positive feedback between its non-inverting input ( Q2 base ) and output ( Q1 collector ) that forces the transition process.
To simplify the circuit, the R < sub > 1 </ sub >– R < sub > 2 </ sub > voltage divider can be omitted connecting Q1 collector directly to Q2 base.
The base resistor R < sub > B </ sub > can be omitted as well so that the input voltage source drives directly Q1 base.
Only Q2 collector should be used as an output since, when the input voltage exceeds the high threshold and Q1 saturates, its base-emitter junction is forward biased and transfers the input voltage variations directly to the emitters.
So, it can be converted to a Schmitt trigger by connecting an additional base resistor R to some of the inputs ( Q1 base in the figure ).
be: Q1 Tower
Currently, cars have to be within 107 % of the fastest Q1 time in order to qualify for the race.
Though many independent professional computer manufacturers such as Supermicro offer blade solutions, the blade server market continues to be dominated by large public IT companies such as HP, which, as of Q1 2011, owns 50. 0 % market share, with IBM coming in 2nd with 20. 2 %, followed by Cisco with 9. 4 % and Dell with 8. 4 %.
In 1979, C / 1979 Q1 ( SOLWIND ) was the first sungrazer to be spotted by US satellite P78-1, in coronographs taken on 30 and 31 Aug 1979.
The standard was expected to be finalized in Q1 2010, but was finally published in July 2011.
0.259 seconds.