To determine car speed for a given combination of engine speed, gear ratio, and tire size, the formula is: Af.

Finnish Defence Forces reported on 3 September 2012 that the United States has not delivered any of the AMRAAM anti-aircraft missiles they had ordered due to a mysterious engine malfunction in cold weather that the manufacturer, Raytheon, has not been able to determine the fault of.

Intake tuning, cylinder head design, valve timing and exhaust tuning determine how effectively an engine scavenges.

Most modern search engines have the ability to analyze a page for keyword stuffing and determine whether the frequency is consistent with other sites created specifically to attract search engine traffic.

The objectives were to obtain postlanding television pictures of the lunar surface, conduct a Vernier engine erosion experiment, determine the relative abundance of the chemical elements in the lunar soil, obtain touchdown dynamics data, and obtain thermal and radar reflectivity data.

This spacecraft was the fourth of the Surveyor series to successfully achieve a soft landing on the moon, obtain post landing television pictures, determine the abundance of the chemical elements in the lunar soil, obtain touchdown dynamics data, obtain thermal and radar reflectivity data, and conduct a Vernier engine erosion experiment.

However, the level of torque currently being produced by the engine will strongly influence spark plug operating temperature because the maximum temperature and pressure occurs when the engine is operating near peak torque output ( torque and RPM directly determine the power output ).

Bing Toolbox provides a way from webmasters to submit a sitemap and web feeds, allowing users to determine the crawl rate, and how many pages have been indexed by their search engine.

If we assume an even firing engine, we can divide 720 degrees by the number of cylinders to determine how often a power stroke occurs.

This is aided by the decompression valve, which decompresses the engine for anything up to 6 revolutions ( generally 3 revolutions is sufficient-a spiral groove on the perimeter of the flywheel is used to determine the number of revolutions and position before top dead centre where the decompressor mechanism disengages and permits compression ) to allow the flywheel to gain speed and inertia to turn the engine through compression, and get the engine to fire.

In many late model automobiles, a mass airflow sensor ( MAF sensor ) is used to accurately determine the mass flowrate of intake air used in the internal combustion engine.

Other factors, including engine displacement, custom coachwork and luxury accessories, such as power brakes, power clutch, and " one-shot " or automatic lubrication systems, help determine whether a car is considered to be a Classic.

Other factors, including engine displacement, custom coachwork and luxury accessories, such as power brakes, power clutch, and " one-shot " or automatic lubrication systems, help determine whether a car is considered to be a Classic.

In this state, the inference engine applies some selection strategy to determine which rules will actually be executed.

Unlike instructions, rules are not executed sequentially and it is not always possible to determine through inspection of a set of rules which rule will be executed first or cause the inference engine to terminate.

The report said the G650 was performing a take off with a simulated engine failure to determine take-off distance requirements at minimum flap setting.

The engine can then determine when the sun will rise / set, and will simulate the position of the sun inside the game.

The towing tank serves for resistance and propulsion tests with towed and self-propelled ship models to determine how much power the engine will have to provide to achieve the speed laid down in the contract between shipyard and ship owner.

If sprayed into the air intake on a car, it can be used to determine whether the spark and ignition system of the car is functioning and the fuel delivery system is not, since the engine will run until the starting fluid vapors in the intake system are exhausted.

Eventually engineers developed a technique of detonating small explosive charges ( which they called " bombs ") outside the combustion chamber through a tangential tube ( RDX, C4 or black powder were used ) while the engine was firing, which allowed them to determine exactly how the running chamber responded to variations in pressure and to determine how to nullify these oscillations.

ARPES can be used to determine the direction, speed and scattering of electrons within the material.

These categories determine the locomotive's combination of physical size, starting tractive effort and maximum permitted speed.

For instance, Bernoulli's equation can be used to determine the pressure at each point on the airfoil from the speed of the velocity field.

LORAN ( LOng RAnge Navigation ) is a terrestrial radio navigation system which enables ships and aircraft to determine their position and speed from low frequency radio signals transmitted by fixed land based radio beacons, using a receiver unit.

The number of knots that passed off the ship and into the water in a given time would determine the speed in " knots ".

Many private employers give standards-based tests to determine whether job applicants have necessary job skills ( such as typing speed ), and nearly all government employees have to take and pass a civil service examination.

Radar is an object-detection system which uses radio waves to determine the range, altitude, direction, or speed of objects.

He stated, "... by their electromagnetic waves use we may produce at will, from a sending station, an electrical effect in any particular region of the globe ; which we may determine the relative position or course of a moving object, such as a vessel at sea, the distance traversed by the same, or its speed.

The Doppler effect is only able to determine the relative speed of the target along the line of sight from the radar to the target.

This corresponds to a radio wavelength of 1 light-nanosecond or 0. 3 m, as can be calculated by multiplying 1 ns by the speed of light ( approximately 3 m / s ) to determine the distance traveled.

This corresponds to radio wavelength 300 m ( AM mediumwave band ), as can be calculated by multiplying 1 µs by the speed of light ( approximately 3 × 10 < sup > 8 </ sup > m / s ) to determine the distance travelled.

Still later, wind-tunnel testing was applied to automobiles, not so much to determine aerodynamic forces per se but more to determine ways to reduce the power required to move the vehicle on roadways at a given speed.

The probabilities of crossover ( pc ) and mutation ( pm ) greatly determine the degree of solution accuracy and the convergence speed that genetic algorithms can obtain.

* 1728 — James Bradley discovers the aberration of starlight and uses it to determine that the speed of light is about 283, 000 km / s

The soldiers use electronic equipment to precisely determine a Walker's speed.

( See wave-particle duality ) This time can be calculated by dividing the wavelength of the light by the speed of light ( approximately 3 x 10 < sup > 8 </ sup > m / s ) to determine the time required for light to travel that distance.

This corresponds to a wavelength of 0. 3 mm, as can be calculated by multiplying 1 ps by the speed of light ( approximately 3 x 10 < sup > 8 </ sup > m / s ) to determine the distance traveled.

In Ethnomusicology, recording a short beep with pitch pipe in ethnographic recordings can be used in playback to determine the playback speed of the Gramophone record or Phonograph cylinder.

Factors including one's speed made good and the nature of heading and other course changes, and the navigator's judgment determine when dead reckoning positions are calculated.

For high accuracy depths, usually restricted to special purpose or scientific surveys, a sensor may be lowered to observe the factors ( temperature, pressure and salinity ) used to calculate sound speed and thus determine the actual sound speed in the local water column.

If a work is divided into several large segments, a last-minute drawing of random numbers may determine the order of the segments for any particular performance.

Instead it means that the thinking in which decision issues has the power to determine the morality of the decision, as in this instance the pressure for renewed practical or legislative attention to the constitutional problems the decision had uncovered might have done.

It will determine the amount of money to be spent by the college and will certify this amount to the board of freeholders, which `` shall appropriate in the same manner as other appropriations are made by it the amount so certified and the amount shall be assessed, levied and collected in the same manner as moneys appropriated for other purposes ''.

undertake economic studies and surveys to determine present and prospective costs of producing water for beneficial consumptive purposes in various parts of the United States by the leading saline water processes as compared with other standard methods.

In connection with any claim decided by the Commission pursuant to this Title in which an award is made, the Commission may, upon the written request of the claimant or any attorney heretofore or hereafter employed by such claimant, determine and apportion the just and reasonable attorney's fees for services rendered with respect to such claim, but the total amount of the fees so determined in any case shall not exceed 10 per centum of the total amount paid pursuant to the award.

For each State ( except the Virgin Islands, Guam, Puerto Rico, and, prior to 1962, Alaska and Hawaii ), determine the average per capita income for the last three years.

Some families already have held weekend rehearsals in their home shelters to learn the problems and to determine for themselves what supplies they would need.

The Federal Government is aiding local governments in several places to survey residential, commercial and industrial buildings to determine what fallout protection they would provide, and for how many people.

Whether it will strike home for you or not will be for you to determine.

The two Governments agree that the rupees accruing to the Government of the United States of America as a consequence of sales made pursuant to this Agreement will be used by the Government of the United States of America, in such manner and order of priority as the Government of the United States of America shall determine, for the following purposes in the amounts shown: ( A )

To determine the rear axle gear ratio for a combination of the other three factors, the formula is: Af.

It is generally an inaccurate method of rating, for the horsepower is that of the compressor motor, and many other components beside it determine how much cooling you'll get.

Look at the physical features of the land to determine how desirable it is for use, what can be done to correct the faults, and what it will cost to make the area meet your needs in comparison to other sites.

The x-ray data did not permit Douglass to determine uniquely the space group, but a negative test for piezoelectricity led him to assume a center of symmetry.

It would appear that it should be possible to determine unique mechanisms for the thermal and photochemical reactions in both the liquid and gas phases and to determine values for activation energies of some of the intermediate reactions of atoms and free radicals, as well as information on the heat of dissociation of the carbon-halogen bond.

The second step in processing was to compare the responses from companies on the AIA list with those from companies on the TR list in order to determine whether it would be appropriate to merge the responses for the purposes of the study.

The lack of adequate data on the aerated lagoon system prompted the developer to construct an aerated lagoon pilot plant to determine its feasibility for treating domestic sewage.

The person using these tests must determine which combination of procedures is practical for any specific item in order to evaluate the dimensional changes of textile fabrics or garments after laundering procedures commonly used in the home or commercial laundry.

In a shifted code, some character codes determine choices between options for the following character codes.