Typically, the chrominance bandwidth is reduced in analog composite video by reducing the bandwidth of a modulated color subcarrier, and in digital systems by chroma subsampling.

Typically digital IIR filters are designed as a series of digital biquad filters.

Typically, an RTU converts the electrical signals from the equipment to digital values such as the open / closed status from a switch or a valve, or measurements such as pressure, flow, voltage or current.

Typically, this involves the use of computer networks, the internet and digital stored value systems.

Typically, private broadcasters worldwide compress their material at 256kbit / s ( stereo ) while their counterparts in public broadcasting ( including the Canadian Broadcasting Corporation, Channel Africa, Deutsche Welle, Radio France Internationale, Radio Canada International, Radio Netherlands, the SABC, the Singapore Broadcasting Corporation, and VOA, to cite a few ) use 384 kbit / s ( although the BBC in the United Kingdom uses 128kbit / s for most of its digital radio broadcasts, the exceptions being Radio 3 and Radio 7 being broadcast at 192kbit / s and 80kbit / s respectively ).

Typically a light meter will include a computer, either digital or analog, which allows the photographer to determine which shutter speed and f-number should be selected for an optimum exposure, given a certain lighting situation and film speed.

Typically one or more regular batteries must be installed to operate it, although some so-called " power stealing " digital thermostats use the common 24 volt AC circuits as a power source, but will not operate on thermopile powered " millivolt " circuits used in some furnaces.

Typically the distribution system for Standard Definition digital TV is based on the MPEG-2 specification, while High Definition distribution is likely to be based on the MPEG-4 meaning that the delivery of HD often requires a new device or set-top box, which typically are then also able to decode Internet Video via broadband return paths.

Typically three settings control digital unsharp masking:

Typically, a digital controller requires:

Typically magnification is related to scaling up visuals or images to be able to see more detail, increasing resolution, using microscope, printing techniques, or digital processing.

Typically studios contain a combination of high-end analogue equipment with low-noise circuitry and digital hardware and plug-ins.

Typically, the digital zoom would not be available until after the optical zoom had been exhausted.

Typically the generic SMS hardware is dual cascade of three subsystems: digital processing and control, A / D or D / A conversion ( codec ), and signal conditioning.

Typically the customer uploads their digital photos to the site and then orders prints and gifts which are then delivered by mail.

Typically, digital stories are produced in intensive workshops.

Typically, when an algorithm is associated with processing information, data is read from an input source, written to an output device, and / or stored for further processing.

Typically one of the two mirrors, the output coupler, is partially transparent.

Typically only one of the new frequencies is desired, and the other signal is filtered out of the output of the mixer.

Typically, a 16 bit analog-to-digital converter may have a dynamic range of between 90 to 95 dB ( Metzler 2005: 132 ), whereas the signal-to-noise ratio ( roughly the equivalent of dynamic range, noting the absence of quantization noise but presence of tape hiss ) of a professional reel-to-reel 1 / 4 inch tape recorder would be between 60 and 70 dB at the recorder's rated output ( Metzler 2005: 111 ).

Typically, ALSA supports up to eight cards, numbered 0 through 7 ; each card is a physical or logical kernel device capable of input, output, or control of sound, and card number 0 is used by default when no particular card is specified.

Typically only one of the new frequencies is desired, and the other signal is filtered out of the output of the mixer.

Typically, light output, overall dimensions, battery compatibility and durability are required to meet minimum limits.

Typically, an amplifier's power specifications are calculated by measuring its RMS output voltage, with a continuous sine wave signal, at the onset of clipping — defined arbitrarily as a stated percentage of total harmonic distortion ( THD )— into specified load resistances.

Typically, a guitar amp's preamplifier section ( known as a ' pre ') provides sufficient gain so that an instrument can be connected directly to its input, and its main amplification section ( known as the ' power stage ') sufficient power to connect loudspeakers directly to its output, both without requiring extra amplification.

** output prefixing describes that the name is emitted on channel before proceeding as Typically, this models either sending a message on the network or a operation.

Typically a current buffer amplifier is used to transfer a current from a first circuit, having a low output impedance level, to a second circuit with a high input impedance level.

Typically helix TWTs achieve less than 2. 5 kW output power.

Typically, such an oscillator has an average output power of 0. 5 to 1. 5 watt.

Typically, power output in excess of 300 hp was available from 3000 rpm to the 7500 rpm maximum, with a peak of 330 – 340 hp at around 5500 rpm.

Typically, a rear-wheel-drive transmission has three shafts: an input shaft, a countershaft and an output shaft.

Typically, the paper is sent to an output tray where any remaining dispersant evaporates, leaving the copies with a faint " kerosene " odor.

Typically the motor coils are driven from a commutator on one end of the shaft, when the generator coils output to another commutator on the other end of the shaft.

Typically, there could be increasing returns at relatively low output levels, decreasing returns at relatively high output levels, and constant returns at one output level between those ranges.

Typically, if output growth slows down, socio-economic inequality ( measured e. g. by the Gini coefficient ) increases.

Typically one of these output devices has to be declared the " primary " device, and only the primary device can display hardware overlays.

Typically this concept confines itself to one publishing company's output ( although concepts such as the Wold Newton family extend the boundaries considerably ), and it is most common in the main superhero universes of DC and Marvel.

Typically, the data is stored in a buffer as it is retrieved from an input device ( such as a mouse ) or just before it is sent to an output device ( such as speakers ).

Typically, in a lower-middle class Jewish family, a son will be sent to an out-of-town school, if financial resources warrant it, while the daughter will attend the local college.

Typically, young children will make an ASL sign in the correct location and use the correct hand motion, but may be able only to approximate the hand shape, for example, using one finger instead of three in signing water.

Typically, the league leader in OPS will score near, and sometimes above, the 1. 000 mark.

Typically, the tallest members of a team will play " center ", " power forward " or " small forward " positions, while shorter players or those who possess the best ball handling skills and speed play " point guard " or " shooting guard ".

Typically each sheet will have either six daily strips of a given title or one Sunday strip.

Typically, the chamber is larger than a cist, and will contain a larger number of interments, which are either excarnated bones or inhumations ( cremations ).

Typically during an attorney's closing argument they will repeat any admissions made by witnesses that favor their case.

Typically a drawing will be filled in based on which hand the artist favors.

Typically this point of convergence will be along the horizon, as buildings are built level with the flat surface.

Typically a single lengthened pseudopod will secrete a hollow stalk that attached the adult to the substrate.

Typically an Eiffel application will be organized with each class in a separate file, and each cluster in a directory containing class files.

Typically the dead time will result in an upper count rate limit of 10 < sup > 4 </ sup > to 10 < sup > 5 </ sup > counts per second depending on the characteristic of the tube being used.

Typically, the refractive index for honey will range from 1. 504 at 13 % humidity, to 1. 474 at 25 %.

Typically, the software system will place data in some well known and mutually agreed upon memory location ( s ), and " ring the doorbell " by writing to a different memory location.

Typically but not always, the protagonist of a wuxia novel will become this leader and command the actions of wulin.

Typically, a Dutch painter of the 17th century ( also known as the Dutch Golden Age ) will fall into one of four categories, a painter of portraits, landscapes, still-lifes, or genre.

Typically, the units are the actual number of threads, but as long as the proportions are maintained, the resulting pattern will be the same.

Typically one will be a high reflector, and the other will be a partial reflector.

Typically, structures made of CMUs will have the top course of blocks in the walls filled with concrete and tied together with steel reinforcement to form a bond beam.

Typically, the restrictions on the disclosure or use of the confidential data will be invalid if

Typically, about 10 % of the mass of a gas cloud will coalesce into stars before radiation pressure drives the rest of the gas away.

Typically the vaulter will begin to angle his body toward the bar as the turn is executed, although ideally the vaulter will remain as vertical as possible.