[permalink] [id link]
The TTL field is set by the sender of the datagram, and reduced by every router on the route to its destination.
from
Wikipedia
Some Related Sentences
TTL and field
The value of the MINIMUM field of the SOA record and the TTL of the SOA itself is used to establish the TTL for the negative answer.
For example, every device ( such as an intermediate router ) forwarding an IP datagram first decrements the time to live ( TTL ) field in the IP header by one.
* The TTL field of IPv4 has been renamed to Hop Limit, reflecting the fact that routers are no longer expected to compute the time a packet has spent in a queue.
* an 8-bit TTL ( time to live ) field.
Under the Internet Protocol, TTL is an 8-bit field.
If the TTL field reaches zero before the datagram arrives at its destination, then the datagram is discarded and an ICMP error datagram ( 11-Time Exceeded ) is sent back to the sender.
The purpose of the TTL field is to avoid a situation in which an undeliverable datagram keeps circulating on an Internet system, and such a system eventually becoming swamped by such " immortals ".
In practice, the TTL field is reduced by one on every hop.
Since the invention of the “ solid state ” transistor in the 1950s and the TTL ( transistor-transistor logic ) that led to the development of the IC ( integrated circuit ) in the 1960s the growth in the field of electronics has been phenomenal.
* TTL: standard DNS time to live field.
A RouteRequest carries the source identifier ( SrcID ), the destination identifier ( DestID ), the source sequence number ( SrcSeqNum ), the destination sequence number ( DestSeqNum ), the broadcast identifier ( BcastID ), and the time to live ( TTL ) field.
The TTL field is 8 bits, its only metric is hop count.
Ethernet does not have a time to live ( TTL ) field in its frame header, so loop avoidance must be arranged by other means.
TTL and is
The time for which a resolver caches a DNS response is determined by a value called the time to live ( TTL ) associated with every record.
The TTL is set by the administrator of the DNS server handing out the authoritative response.
If the resulting TTL is 0, the packet is discarded and an ICMP Time To Live exceeded in transit message is sent to the datagram's source address.
Time to live ( TTL ) is a mechanism that limits the lifespan or lifetime of data in a computer or network.
In computing applications, TTL is used to improve performance of caching or improve privacy.
In the IPv4 header, TTL is the 9th octet of 20.
The maximum TTL value is 255, the maximum value of a single octet.
In theory, under IPv4, time to live is measured in seconds, although every host that passes the datagram must reduce the TTL by at least one unit.
An older common TTL value for DNS was 86400 seconds, which is 24 hours.
TTL values are " per record " and setting this value on specific records is normally honored automatically by all standard DNS systems world-wide.
A dedicated voltage comparator chip such as LM339 is designed to interface with a digital logic interface ( to a TTL or a CMOS ).
Transistor – transistor logic ( TTL ) is a class of digital circuits built from bipolar junction transistors ( BJT ) and resistors.
TTL is notable for being a widespread integrated circuit ( IC ) family used in many applications such as computers, industrial controls, test equipment and instrumentation, consumer electronics, synthesizers, etc.
The designation TTL is sometimes used to mean TTL-compatible logic levels, even when not associated directly with TTL integrated circuits, for example as a label on the inputs and outputs of electronic instruments.
TTL and set
The tracert ( traceroute ), Pathping commands are implemented by transmitting UDP datagrams with specially set IP TTL header fields, and looking for ICMP Time to live exceeded in transit ( above ) and " Destination unreachable " messages generated in response.
Traceroute works by increasing the TTL value of each successive set of packets sent.
Nameservers may also have a TTL set for NXDOMAIN ( acknowledgment that a domain does not exist ); but they are generally short in duration ( three hours at most ).
Newer DNS methods that are part of a DR ( Disaster Recovery ) system may have some records deliberately set extremely low on TTL.
While it contains no microprocessor, it used the 4004 programming instruction set and its custom TTL was the basis for the Intel 8008, and for practical purposes the system behaves approximately as if it contains an 8008.
In manual mode, a black needle points out the shutter speed recommended by the built-in, open aperture, through-the-lens ( TTL ), silicon photodiode ( SPD ) light meter, with 60 / 40 percent centerweighting, while a translucent green needle shows the actual camera set shutter speed.
TTL and by
For small-scale logic, designers now use prefabricated logic gates from families of devices such as the TTL 7400 series by Texas Instruments and the CMOS 4000 series by RCA, and their more recent descendants.
In 1973, the KA10 was replaced by the KI10, which used TTL SSI.
They are activated by AC control signals or DC control signals from Programmable logic controller ( PLCs ), PCs, Transistor-transistor logic ( TTL ) sources, or other microprocessor and microcontroller controls.
When a caching ( recursive ) nameserver queries the authoritative nameserver for a resource record, it will cache that record for the time ( in seconds ) specified by the TTL.
After introduction in integrated circuit form in 1963 by Sylvania, TTL integrated circuits were manufactured by several semiconductor companies, with the 7400 series by Texas Instruments becoming particularly popular.
TTL was invented in 1961 by James L. Buie of TRW, " particularly suited to the newly developing integrated circuit design technology ", and it was originally named transistor-coupled transistor logic ( TCTL ).
The first commercial integrated-circuit TTL devices were manufactured by Sylvania in 1963, called the Sylvania Universal High-Level Logic family ( SUHL ).
TTL also became important because its low cost made digital techniques economically practical for tasks previously done by analog methods.
The main disadvantage of TTL with a simple output stage is the relatively high output resistance at output logical " 1 " that is completely determined by the output collector resistor.
At low input voltage, the TTL input sources current which must be absorbed by the previous stage.
A TTL input signal is defined as " low " when between 0 V and 0. 8 V with respect to the ground terminal, and " high " when between 2. 2 V and 5 V ( precise logic levels vary slightly between sub-types and by temperature ).
0.314 seconds.