[permalink] [id link]
The melting point of crystallized honey is between, depending on its composition.
from
Wikipedia
Some Related Sentences
melting and point
The silicate fractions of stony meteorites show gallium / germanium ratios similar to those of tektites because they too have undergone melting at some point in their histories.
For some substances, auxiliary properties such as the melting point are given.
the physical property values include hardness, melting point, and specific gravity.
It is likely to have a much higher melting point than does iodine, on par with those of bismuth and polonium.
Unlike pure metals, most alloys do not have a single melting point, but a melting range in which the material is a mixture of solid and liquid phases.
However, for most alloys there is a particular proportion of constituents ( in rare cases two )— the eutectic mixture — which gives the alloy a unique melting point.
Ancient civilizations took into account the mixture and the various properties it produced, such as hardness, toughness and melting point, under various conditions of temperature and work hardening, developing much of the information contained in modern alloy constitution diagrams.
Classical methods ( also known as wet chemistry methods ) use separations such as precipitation, extraction, and distillation and qualitative analysis by color, odor, or melting point.
The relatively low melting point of brass ( 900 to 940 ° C, 1652 to 1724 ° F, depending on composition ) and its flow characteristics make it a relatively easy material to cast.
Since lead has a lower melting point than the other constituents of the brass, it tends to migrate towards the grain boundaries in the form of globules as it cools from casting.
It has exceptional flexural rigidity ( Young's modulus 287 GPa ) and a reasonably high melting point.
Crystalline boron is a very hard, black material with a high melting point of above 2000 ° C.
Its melting temperature of 1000 K ( 727 ° C, 1341 ° F ) is intermediate between those of the lighter strontium ( 1050 K ) and heavier radium ( 973 K ); however, its boiling point of 2170 K ( 1897 ° C, 3447 ° F ) exceeds that of strontium ( 1655 K ).
Its density of 14. 78 g / cm < sup > 3 </ sup > lies between those of curium ( 13. 52 g / cm < sup > 3 </ sup >) and californium ( 15. 1 g / cm < sup > 3 </ sup >), as does its melting point of 986 ° C, below that of curium ( 1340 ° C ) but higher than that of californium ( 900 ° C ).
The temperature of the phase transition is believed to be quite close to the melting point.
The melting point of bronze varies depending on the actual ratio of the alloy components and is about.
Paired DNA and RNA molecules are comparatively stable at room temperature but the two nucleotide strands will separate above a melting point that is determined by the length of the molecules, the extent of mispairing ( if any ), and the GC content.
Lists of the elements are available by name, by symbol, by atomic number, by density, by melting point, and by boiling point as well as ionization energies of the elements.
Since helium remains a liquid even at absolute zero at atmospheric pressure, it has only a boiling point, and not a melting point, in conventional presentations.
It is a steely-gray, lustrous, hard metal that takes a high polish and has a high melting point.
Like zinc, it prefers oxidation state + 2 in most of its compounds and like mercury it shows a low melting point compared to transition metals.
Curium is a hard, dense, silvery metal with a relatively high melting point and boiling point for an actinide.
melting and crystallized
Individual plutons are crystallized from magma that traveled toward the surface from a zone of partial melting near the base of the Earth's crust.
Migmatites are composed of a leucosome, new material crystallized from incipient melting, and a mesosome, old material that resisted melting.
Past episodes of melting and volcanism at the shallower levels of the mantle have produced a thin crust of crystallized melt products near the surface, upon which we live.
melting and honey
Since honey normally exists below its melting point, it is a supercooled liquid.
However, honey will take substantially longer to liquify when just above the melting point than it will at elevated temperatures.
This may be spread on hot toast, melting the wax, or may be chewed as a treat, releasing the honey.
melting and is
Limitations on the lengths of these sequences diminish the stability of the comparatively short crystallites which can be formed, and this is reflected in a broadening of the melting range.
The temperature at which melting begins is called the solidus, and the temperature when melting is just complete is called the liquidus.
This country is, after all, a huge melting pot.
Celsius conducted many geographical measurements for the Swedish General map, and was one of earliest to note that much of Scandinavia is slowly rising above sea level, a continuous process which has been occurring since the melting of the ice from the latest ice age.
So-called structure zone models were developed to describe the micro structure and ceramics of thin films as a function of the homologous temperature T < sub > h </ sub > that is the ratio of deposition temperature over melting temperature.
According to these models, a necessary ( but not sufficient ) condition for the occurrence of amorphous phases is that T < sub > h </ sub > has to be smaller than 0. 3, that is the deposition temperature must be below 30 % of the melting temperature.
Thus Dorothy Tutin as Desiree, the touring thesp eventually reunited with her quondam lover, is not the melting romantic of previous productions but a working mother with the sharpness of a hat-pin.
Higher GC content results in higher melting temperatures ; it is, therefore, unsurprising that the genomes of extremophile organisms such as Thermus thermophilus are particularly GC-rich.
It is believed that melting Arctic ice will cause sea levels to rise and flood costal areas.
melting and between
This property lends a suitable balance between easy melting and good gel stability at relatively high temperatures.
For example, the density of water increases between its melting point at 0 ° C and 4 ° C ; similar behavior is observed in silicon at low temperatures.
Chihuly said the melting wall represented the " dissolution of barriers " between people.
While melting, any energy added breaks the hydrogen bonds between ice ( water ) molecules.
The organisation created a new prototype bar in 1889 at the first General Conference on Weights and Measures ( CGPM: Conférence Générale des Poids et Mesures ), establishing the International Prototype Metre as the distance between two lines on a standard bar composed of an alloy of ninety percent platinum and ten percent iridium, measured at the melting point of ice.
* 1889 September 28The first General Conference on Weights and Measures ( CGPM ) defines the metre as the distance between two lines on a standard bar of an alloy of platinum with ten percent iridium, measured at the melting point of ice.
Neptunium has the largest liquid range of any element, 3363 K, between the melting point and boiling point.
Paraffin wax ( or simply " paraffin ", but see alternative name for kerosene, above ) is mostly found as a white, odorless, tasteless, waxy solid, with a typical melting point between about, and having a density of around 0. 9 g / cm < sup > 3 </ sup >.
* 1889 – The first General Conference on Weights and Measures ( CGPM ) defines the length of a meter as the distance between two lines on a standard bar of an alloy of platinum with ten percent iridium, measured at the melting point of ice.
It is a p-T diagram indicating the solid and liquid regions separated by the melting curve ( between the liquid and solid state ) and the liquid and gas region, separated by the vapor-pressure line.
Thorium has one of the largest liquid temperature ranges of any element, with 2946 ° C between the melting point and boiling point.
The low thermal expansion and high melting point and strength of tungsten originate from strong covalent bonds formed between tungsten atoms by the 5d electrons.
Tacticity may also be inferred by measuring another physical property, such as melting temperature, when the relationship between tacticity and that property is well-established.
In 1701 Isaac Newton proposed a scale of 12 degrees between the melting point of ice and body temperature.
Another important mechanism of metamorphism is that of chemical reactions that occur between minerals without them melting.
This is in contrast with soldering and brazing, which involve melting a lower-melting-point material between the workpieces to form a bond between them, without melting the workpieces.
The melting temperature varies smoothly between the two endmembers, as do other properties.
Today, Greenland, Antarctica, and the northern portions of Europe, Asia, and North America are situated such that a minor change in solar energy will tip the balance between year-round snow / ice preservation and complete summer melting.
The compact size of the halogen lamp permits a reasonable size for portable projectors, although heat-absorbing filters must be placed between the lamp and the film to prevent melting.
0.356 seconds.