Internet Experiment Note ( IEN ) 96 ( 1979 ) describes an early RF cable modem system.

Note that the top slice has not been internally sprayed for RF shielding

Note that the Contax ( Germany ) 35 mm RF camera of 1932 had a vertical travel FP shutter with dual brass-slatted roller blinds with adjustable spring tension and slit width, and a top speed of 1 / 1000 sec.

* Agilent ( July 5, 2006 ), Fundamental of RF and Microwave Power Measurements ( Part 2 ), Application Note 1449-2, Agilent Technologies, Tektronix

Note that the simultaneous transmission of two tones directly at RF loses the constant-envelope property of the single tone system.

( Note: bandwidth is proportional to where = bit time ) Therefore, the bandwidth of the data signal is and the bandwidth of the spread spectrum signal is.

Note also that in most spoken languages, the sounds representing successive letters blend into each other in a process termed coarticulation, so the conversion of the analog signal to discrete characters can be a very difficult process.

Note that the constant of proportionality between the signal and conjugate beams can be greater than 1.

Note that the non-inverting input of the operational amplifier will need a path for DC to ground ; if the signal source might not give this, or if that source requires a given load impedance, the circuit will require another resistor — from input to ground.

Note: Bandwidth compression implies a reduction in normal bandwidth of an information-carrying signal without reducing the information content of the signal.

Note: Call set-up time is the summation of: ( a ) call request time — the time from initiation of a calling signal to the delivery to the caller of a proceed-to-select signal ; ( b ) selection time — the time from the delivery of the proceed-to-select signal until all the selection signals have been transmitted ; and ( c ) post selection time — the time from the end of the transmission of the selection signals until the delivery of the call-connected signal to the originating terminal.

Note: The size of this jam signal is clearly beyond the minimum allowed frame-size of 64 bytes.

Note 1: A data transmission circuit includes any required signal conversion equipment.

Note that the line-coded signal and a signal produced at a terminal may differ, thus requiring translation.

:: Note: < span id =" linear_bus_note "></ span > The two endpoints of the common transmission medium are normally terminated with a device called a terminator that exhibits the characteristic impedance of the transmission medium and which dissipates or absorbs the energy that remains in the signal to prevent the signal from being reflected or propagated back onto the transmission medium in the opposite direction, which would cause interference with and degradation of the signals on the transmission medium.

Note: The carrier wave may continue unmodulated or it may be modulated by another signal source, such as a subcarrier.

* Note 1: The designators for T-carrier in the North American Digital multiplex hierarchy correspond to the designators for the digital signal ( DS ) level hierarchy.

Note: the comma after e. g., is not italicized when attached to another signal ( whether supportive or not ), but is italicized when e. g. appears alone.

Note in particular the ' deep fades ' where signal strength can drop by a factor of several thousand, or 30-40 dB.

Note that windows applied to the MDCT are different from windows used for other types of signal analysis, since they must fulfill the Princen-Bradley condition.

Note that IMRR is not a measurement of the performance of the IF stages or IF filtering ( selectivity ); the signal yields a perfectly valid IF frequency.

Signal processors, such as four-phase modems, cannot change the DSR, but the modulation rate depends on the line modulation scheme, in accordance with Note 4.

Note the natural sign in the key signature marking the typical subdominant modulation.

( Note: So far as State Police cars are concerned, only their replacement is under this division ).

Note, however, that it is six inches shorter at the forward end.

Note another piece of wood six inches wide is fastened to the transom between these pieces.

Note: If 1/2-inch panel board is used inside and out, or 5/8-inch one side and 3/8-inch the other, and 1/8-inch glass is used, stock lumber in Af, Af, and Af can be used in making the glass panels.

Note that the mass threshold is four times that of 1958 Alpha and that the flux is one fifth as large.

Note that the mass scale is one to two orders of magnitude greater than some previously used ; ;

Note also that if Af, then Af is divisible by the polynomial p, because Af contains each Af as a factor.

Note that flexural strength is not always improved by simply increasing the density, nor is the change always proportional from one formulation to another.

Most European domestic power supplies run at 230 V, so the current drawn by a particular European appliance ( in Europe ) will be less than for an equivalent American one ( in the United States ).< ref group =" Note "> The formula for power is given by

Note that this premise uses the phrase " is not ", a form of " to be "; this and many other examples show that he did not intend to abandon " to be " as such.

Note: This list is limited to linguists who have worked specifically on the Altaic problem since the publication of the first volume of Ramstedt's Einführung in 1952.

Note that any model of ZF ¬ C is also a model of ZF, so for each of the following statements, there exists a model of ZF in which that statement is true.

Note that there is no directly corresponding concept in the German language.

Note that " completeness " has a different meaning here than it does in the context of Gödel's first incompleteness theorem, which states that no recursive, consistent set of non-logical axioms of the Theory of Arithmetic is complete, in the sense that there will always exist an arithmetic statement such that neither nor can be proved from the given set of axioms.

Note that the above formula is only applicable to classical ideal gases and not Bose – Einstein or Fermi gases.

Note that this pressure increase is more than a simple 10: 1 compression ratio would indicate ; this is because the gas is not only compressed, but the work done to compress the gas has also heated the gas and the hotter gas will have a greater pressure even if the volume had not changed.

Note that this is not the same as a monophyly in which all descendants of a common ancestor are included.

Note: because Solar System bodies are never perfect diffuse reflectors, astronomers use empirically derived relationships to predict apparent magnitudes when accuracy is required.

Note that this is subtly different to the ' thanks ' list in the original BBC Model B.